Introduction to Part Studios
Table of Contents
Introduction and Scope
This page contains notes from the Introduction to Part Studios course available at onshpae. This page essentially pulls together all of the course’s key takeaways.
01 Course Introduction
Start a Part
- Onshape’s use of sketches is more flexible than more traditional 3D CAD systems.
- Create features with a whole sketch, or portions of the sketch geometry.
- Sweep and Revolve inherit the same flexible behavior.
Part Studio Interface
- This section shows the interactive UI with additional information.
Filtering and Organizing the Feature List
- Folders help organize not only your Documents page, but Part Studios as well.
- To remove all contents from a folder, right-click the folder in the Feature list and select Unpack folder.
- Filter by name or type to further narrow down the Feature list.
02 Basic Features
Extrude
- The Extrude feature extends a sketch along a specified direction to create depth.
- Select from multiple end conditions.
- Extrude solid parts, surfaces, or thin solids.